Water Level Indiacator

Components:-


  • BC 547 Transistor - 4 Pieces
  • 220 ohm Resistor - 6 Pieces
  • Buzzer - 1 Piece
  • 9v Battery With Cap - 1 Piece
  • Glass Epoxy Copper Clad PCB  - 1 piece
  • Jumper wires
  • LED - 3 Pieces
  • Plastic container - 1 Piece
  • 1x2 Green connector - 1 Piece


Circuit :-



Layout :-




Working:-

This is a simple electronic project, In which we are using 4 BC547 transistors. Here R1, R2, R3 and Base of T1 is representing four levels of water and positive terminal of battery is going in water.
When the water level will be reach at R3 then T4 transistor will be work as a switch and LED will be turn on. Same process will be repeat when water level will be reach at R2, R1, and Base of T1.
LED's will be turn on at R2 and R1. T1 is a top level of tank and buzzer is connect with this point so when the water will be reach at the top level of tank then buzzer will be turn on.

Comments

Post a Comment

Popular posts from this blog

Smart Blind stick Code

Code int trigpin = 4; int echopin = 5; int buzzer= 3; long duration; int distance; void setup() {   pinMode(3,OUTPUT);   pinMode(trigpin, OUTPUT);   pinMode(echopin, INPUT);    } void loop() {   digitalWrite(trigpin, LOW);   delayMicroseconds(2);   digitalWrite(trigpin, HIGH);   delayMicroseconds(10);   digitalWrite(trigpin, LOW);      duration = pulseIn(echopin, HIGH);   distance = duration*0.034/2;   Serial.print("Distance: ");   Serial.println(distance);      if(distance<30)   {     digitalWrite(3, HIGH);   }   else   {     digitalWrite(3, LOW);   } }
Read more

Musical doorbell project for students

Image
Components using in this projects are :- UM66 ic - 1 BC 547 - 1 Glass epoxy board - 1 Self lock switch - 1 1x2 Screw terminal - 1 Speaker - 1 100 ohm resistor - 1 9v battery + cap - 1 UM66T  is a melody IC. It is basically intended for use in Telephones, toys, bells etc. There is one inbuilt tone and a beat generator in this ic. The tone producer is a programmed separator which produces certain frequencies. These frequencies are a part of the oscillator frequency as well as the beat generator is also a programmed divider which includes 15 available beats. Four beats of these can be selected. When power is turned on, then melody begins from the first note as well as melody generator is reset. The external npn transistor which is connected to the output of UM66 can drive to speaker. There are so many versions of UM66T are available today which produce tone of different songs. For example, UM66T01 generates tone for songs ‘Jingle bells’, ‘Santa Clau...
Read more